The Destroyer Chassis is built to be MHS compatible with an OD 1.24" (main body) and pommel lips similar to MHS system from TCSS
**** this is
NOT MHS approved or TCSS approved ****
*** the chassis can be used with or without a crystal chamber ***
** see highlighted links for extra products related to this chassis **
--------chassis specification:--------
chassis total length including crystal chamber 6.525" without the crystal chamber 4.365"
built to hold Prizm 5.1 soundboard.
built in place for Li-Ion 18650 3.7V battery.
built in place for a 28mm bass speaker.
built in place for Switchcraft 2.1mm Power Jack
inner holes for wiring.
a cover cap for the soundboard
--------
Crystal chamber specification:--------
Crystal chamber is made from three parts, 2x LED holders, and chamber body
** Crystal chamber is a separate
preaches **- crystal chamber has a built holes for two 5mm LED to light the crystal.
- crystal chamber built for a 1.5" long and 0.42" thick crystal.
- 3D printed crystal is available in my store: The Destroyer crystal
- to hold the crystal chamber with the chassis you will need:
- six 2.8mm (0.114") solid brass rods, length will vary (depends on your built).
- three will go thru the crystal chamber and thru most of the chassis
- three will go thru the crystal chamber and a small part of the chassis. link: solid rods
- 3mm led holders are available for eight 3mm led's (you will need to buy x4 each holder holds two LED)
* printing in metal can have ± 0.125mm change in size
** Chassis have a small place for resistors, a professional installer is recommended
*** some minor modification may be needed (printing can shrink the rods holes by 0.1mm or less)