This is a
full-color 1:144 3D print of the Albatros D.I 391/16 of Leutnant Karl Heinrich Büttner of Jasta 2. In late 1916 Büttner flew this monogrammed plane until it was brought down and captured by a B.E.2c of №8 Squadron RFC. After its capture, it was repainted with British roundels and was extensively tested. The exact dark shade used on the fuselage is unknown, but it is depicted here as the same red-brown used on the wings, since such paint was probably in ready supply. This paint scheme also assumes that -- after its life as a prototype -- 391/16 was repainted in the Albatros three-color camouflage scheme.
No painting is necessary -- this model comes printed in full color, ready to use. It comes with an integral flight peg for mounting on game flight stands (not included), which can be carefully removed with a cutting tool, if desired. The peg is designed for a fairly tight fit; you can file it down slightly if you prefer a looser fit. The model does not come with a flight stand, maneuver deck, or plane card. You can find an unofficial plane card for this plane in this paint scheme at
https://linen.miraheze.org/wiki/File:AlbD1-Buttner-card.jpg.
Material choice: High-Definition Full Color has a smoother, satiny surface and deeper colors; Full Color Nylon 12 (MJF) makes a less expensive alternative, with a rougher, matte surface and less deep blacks. Both are robust materials and fine for gaming. Attached here is a picture that shows the difference between the surfaces. "Matte HDFC" choice means the prints are spray-coated in the factory, and the difference with the coating is subtle. You can find more material photos and comparisons at
https://www.wingsofwar.org/forums/showthread.php?35581-Material-HDFC-vs-Full-Color-Nylon-12-(MJF).
If you are willing to prepare and paint models, you can find an inexpensive single-color print of an Albatros D.I at
https://shpws.me/OKne. Plane statistics and gaming information may be found at
https://linen.miraheze.org/wiki/Albatros_D.I. Please see this notice for information about fixing slight warping of Shapeways prints:
https://poeland.com/Shapeways/shapeways-warping.html.