WPL D12 rear axles for standard hex wheels

This is a pair of adaptors for the WPL D12 to allow the fitment of any standard hex wheel and M4 lock nut.

These fit over the existing hexes on the ends of the axle and just require drilling through the 1.5mm hole to allow a standard drive pin to be inserted to lock these onto the  axle. If you wish to reduce the amount the wheels stick out you can cut upto 5mm off each end of the standard drive hexes before attaching and drilling the 1.5mm hole.

Please see my front adaptors too!

I'd advise selecting the PA12 materials for the increased strength for the threads. I'd only recommend the versatile plastics for light use (not drifting!)