Click and drag to rotate
Pebble 2 buttons | logo all-in-one 3d printed

DIGITAL PREVIEW
Not a Photo

Pebble 2 buttons | logo all-in-one 3d printed
Pebble 2 buttons | logo all-in-one 3d printed

DIGITAL PREVIEW
Not a Photo

Pebble 2 buttons | logo all-in-one 3d printed
Pebble 2 buttons | logo all-in-one 3d printed

DIGITAL PREVIEW
Not a Photo

Pebble 2 buttons | logo all-in-one 3d printed
Pebble 2 buttons | logo all-in-one 3d printed

DIGITAL PREVIEW
Not a Photo

Pebble 2 buttons | logo all-in-one 3d printed
Pebble 2 buttons | logo all-in-one 3d printed

DIGITAL PREVIEW
Not a Photo

Pebble 2 buttons | logo all-in-one

Print With Shapeways
Choose Your Material
$12.50
Choose your color and finish
QTY

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
Pebble 2 (SE and HR) smartwatch replacement side plates and buttons.

This is the newest model available.  The buttons are the same as the newest plain version, but incorporate a pebble logo on the single button side.  The plates and buttons are printed as one interlocking part: the buttons are mechanical and have a satisfying click when pressed.

If you want more than one pair, you can buy two sets printed together (1x plain and 1x logo) here.

You will need a pin and/or a small craft knife to remove the old button material.   For the new buttons, all you need to do is remove the sprues, clean up the edges with a fingernail, nail file or fine sandpaper, and glue them on.    When handling the new buttons,  please be gentle as the material is brittle, and the button plates will snap if they bend.

If your buttons do not move/are stuck when they arrive, please watch this video first on how to free them up.


Here's a short video tutorial on how to fit the buttons. Warning, the video contains flashing images (from the HR monitor on the pebble 2 which came on when I switched on the watch half way through).

The plates and buttons are translucent, but can be painted. There's a tutorial on how to clean and paint this material here.

Please note that due to the nature of this design, the watch will no longer be waterproof.
You might also want to test out your chosen glue on the small bar piece which you won't be using, before you glue the plates to the case.  Silicone craft glue applied in a fine layer works well. Superglue will also work well, but you might want to use "slow" superglue!


If you find that Shapeways' shipping costs to your country are very high, please have a look at my website, as I normally keep some buttons in stock.  https://favouritehumandesign.com/product-category/pebble
Details
What's in the box:
P2 All 1 new logo pebble (repaired)
Dimensions:
0.35 x 4.62 x 1.95 cm
Switch to inches
0.14 x 1.82 x 0.77 inches
Switch to cm
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.