This grip improves the holding feeling of
PENTAX Q, and respects 'Auto110 winder'
It is an another version of 'Grip for PENTAX Q'
with storage slot for spare battery.
To install the grip, tighten the tripod screw on the bottom of the camera.
Additional tripod screw is equipped on the bottom of the grip.
Spare 'D-LI68' battery can be installed into the storage slot.
By checking the 'slot window' equipped behind the grip, you can see whether spare battery is installed.
It is an
assembly kit. The following items are also required.
- M2 x 7 mm screw ... 5 pcs.
- M2 nut ... 5 pcs.
and, you need some tools to assemble it.
- Screwdriver
- Nippers
- Cutter
- Tweezers
Assembly manual (More photos in
Twitter's moment)
- Grip, grip cap, battery slot cover, and fixing screw are connected with 'bar'. Cut the bar by nippers.
- Install M2 nuts into the top of the grip (5 places). Tweezers will help you.
- Set the fixing screw into the specified place on the grip.
- Install the grip cap into the top of the grip. With M2 screws, fix the grip cap to the grip (5 places).
- After checking that the screw heads does not hit the bottom surface of your camera, install the grip by tightening the fixing screw completely.
- Finally, install the battery slot cover.
*Note
Only applicable for PENTAX Q. Sorry, not applicable for PENTAX Q10/Q7/Q-S1.
Clean up plastic powder before using.
By tolerance etc., you may feel tight when you attach the grip to your camera.
Don't screw tight with your force. Tighten and loosen little by little, finally, you can install!
Don't forget '
AT YOUR OWN RISK'