Strap Adapter for Ricohflex

Ricohflex is cheap and good TLR camera using 120 film.
However, it has a problem that cannot be attached common camera straps.

This adapter allows to attach common camera straps to Ricohflex.
Ricohflex with leather case bracket (its diameter is 10mm and shaft diameter is 5mm) is suitable for this adapter.
It is a snap-lock type adapter. Please refer to the attached pictures.

* how to use
First, two printed parts are joined by a small 'bar'. Cut the bar by a nipper.
Second, insert the leather case bracket of Ricohflex into the adapter's hole.
The flat side of the adapter is set to the camera side.
Then, put a force on the adapter, lock the leather case bracket into a small hole of the adapter.
Finally, you can attach your favourite camera straps !

* Note
If you feel tight when locking to the bracket,  you may need to scrape hole of the adapter.
After installation, pull on the strap to confirm that the adapter is locked.
To remove the adapter, put a force on the adapter in the opposite direction.
Don't forget 'AT YOUR OWN RISK'
I had installed the adapter in my own 'Ricohflex model VI'.