You must be logged in and verified to contact the designer.
Product Description
Want to custom make a 9" for your 1/12th scale project? We've got you covered! This housing mates up with 1/4" brass tubing on either end, the drivers side should be .100" shorter for the yoke offset, and is supported by sliding 7/32" tubing cut the same length as the 1/4" tubing, then inserting 3/16" through the center of those tubes and teh center of the housing. Carefiully cut the pumpkin off, sand down the remainder of the pins, and use the small locating pins to attach it to the housing for the most tricked-out rear you can put on you project! The Model Behavior driveshaft kit yokes will fit tightly into the pumkin and the snout holes are open for detailing with RB motion bolt heads.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: