Click and drag to rotate
mojave drift rear body mount 3d printed

DIGITAL PREVIEW
Not a Photo

White Natural Versatile Plastic
mojave drift rear body mount 3d printed
mojave drift rear body mount 3d printed

DIGITAL PREVIEW
Not a Photo

mojave drift rear body mount

Print With Shapeways
Choose Your Material
$17.98
Choose your color and finish
QTY

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
This part was designed to be the rear body mount for a stretched 3racing sakura d4 rwd with a full length RC4WD mojave body on it. 

To use this mount you CANNOT have the battery mounted behind the rear shock tower as this mount uses the factory holes for that battery mount!

To use this mount on a 3racing sakura d4 rwd you WILL need to trim the bed to clear the rear shocks and shock tower!

To attach this part to a 3racing sakura d4 rwd, first use 2 m3 screws through the lower holes (on the flat side of the part) and mount them to the holes that are used for the rear battery mount. Then place the body on top and line everything up and mark the 2 holes for the upper mount from the bottom side. Then remove the body and drill 2 more holes, using an 1/8 inch drill bit. Next place the body back on and use 2 m3 screws to attach the body to the mount. You may need to use longer screws and put a nut on the bottom side to secure the bed.
Details
What's in the box:
drift truck rear body mount
Dimensions:
8.3 x 3.2 x 3 cm
Switch to inches
3.27 x 1.26 x 1.18 inches
Switch to cm
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.