test print from my 3d printer. the cape is a paper prototype.
Mistress of Flame Chest Armor
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$7.00
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
This is a chest plate for my RID Windblade to TR Mistress of Flame kit. NOTE: This does not clip on/off. It has to be glued in place. I suggest Apoxie Sculpt or a similar product.
I use this chest plate to hold the cape in place. A pattern for the cape can be found here:
http://www.tfw2005.com/boards/attachments/mofcape-png.27877670/
For cape scale, the bottom of the cape (the part at her feet) is approximately 99mm. Note that the pictured cape is a paper pattern. To make a better cape, I'd suggest getting some tan t-shirt (Jersey knit) fabric from your local craft store. It can be cut to the pattern and will not fray. So, no sewing is required.
Head, hammer, and back armor are sold separately.
Head: http://shpws.me/Pnbu
Hammer: http://shpws.me/Pnbt
Back Armor: http://shpws.me/Pnbv
I use this chest plate to hold the cape in place. A pattern for the cape can be found here:
http://www.tfw2005.com/boards/attachments/mofcape-png.27877670/
For cape scale, the bottom of the cape (the part at her feet) is approximately 99mm. Note that the pictured cape is a paper pattern. To make a better cape, I'd suggest getting some tan t-shirt (Jersey knit) fabric from your local craft store. It can be cut to the pattern and will not fray. So, no sewing is required.
Head, hammer, and back armor are sold separately.
Head: http://shpws.me/Pnbu
Hammer: http://shpws.me/Pnbt
Back Armor: http://shpws.me/Pnbv
Details
What's in the box:
mofchest1
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
