Product Description
This is a small tram style coach, based on the Clogher Valley Railway's coaches, but without the clerestory roof. Because of the detailed panel work on these coaches they are only available to print in Smooth Fine Detail Plastic.
The print configuration in two halves cuts down the amount of support material by a considerable amount and therefore reduces the cost. It still allows for the fitting of internal details and glazing before the coach is assembled.
I have designed this coach to use the Kato 11-099 bogie sets, which will clip in place - a small amount of fettling may be required to allow the clips to engage and for the bogie to turn freely. However, other bogie sets could be used.
Couplings will be required to complete the coach. Other details may be added such as bass etched mesh to the balcony ends at each side of the central fall plates and hand rails to the side of the steps.
You can see how the prototype model was built on the Model Engine Works blog at:
http://modelengineworks.blogspot.co.uk/2017/12/009-tram-coach.html
The print configuration in two halves cuts down the amount of support material by a considerable amount and therefore reduces the cost. It still allows for the fitting of internal details and glazing before the coach is assembled.
I have designed this coach to use the Kato 11-099 bogie sets, which will clip in place - a small amount of fettling may be required to allow the clips to engage and for the bogie to turn freely. However, other bogie sets could be used.
Couplings will be required to complete the coach. Other details may be added such as bass etched mesh to the balcony ends at each side of the central fall plates and hand rails to the side of the steps.
You can see how the prototype model was built on the Model Engine Works blog at:
http://modelengineworks.blogspot.co.uk/2017/12/009-tram-coach.html
Details
More From This Shop
$21.15
$14.14
