EBT double water column w wire molds

This builds two East Broad Top water columns. A wire mold is included for the flat iron valve handle pivot and spout stop, as well as the spout handle and track. The flat iron piece is made by shoving the male part of the mold into the female part with the flat stock between the two. Typically, with brass no further bending is needed.

Sometimes these prints are a bit bowed. They can be straightened by heating carefully with a lighter or very hot water. BE CAREFUL because the Frosted Ultra Detail material is fairly brittle at room temperature.

​Cut the base off the column and cut the column to length so when it is inserted in the base, the counterweight ring rests on the base. The column can be rotated in the base.