This is
ONLY for the
Korbanth LS6 saber. It's made mainly for the V2 Version, with no access under the clamp section, but it's 100% compatible with the Hero Version. If you don't need a crystal chamber or you want to use the Gullwings, you got more options:
Korbanth LS6 Hero Chassis NB (Nano Biscotte V4.0)
Korbanth LS6 Hero Chassis PRIZM v5.1
Korbanth LS6 Hero Chassis Spark 2/Igniter 3 & 2/Spark Color 2
About the chassis:
The chassis need to slide to access the Recharge Port and the MicroSD card, make sure to leave long enough wires to make this possible.
I always recommend using a retention screw for the chassis.
About the Crystal Chamber:
Any Quartz Crystal with a maximum diameter of 7mm (5mm recommended) and an aproximate length of 18mm will go. If you don't want to worry about fitting, cutting or sanding, there's one available here:
https://shpws.me/OmOM
Specs:
It will hold any
Li-Ion 18650 Battery Cell, the
VECO 20mm 4Ω 3W Bass Speaker (sold at JQ Sabers, The Saber Armory, The Custom Saber Shop, etc), the
Switchcraft High Quality 2.1mm Power Jack (sold at JQ Sabers, The Saber Armory, The Custom Saber Shop, etc) and the
Nano Biscotte V4.0/3.0 from Plecter Labs.
You will also need (as shown in the picture #4):
- 1x 5mm round LED
- 1x 5mm chromed LED holder (sold at eBay, Aliexpress, etc)
- 1x Crystal
Preparing the Crystal Chamber:- 1) Cut the LED Holder threads to 4.5mm.
- 2) Glue the LED Holder to the Crystal Chamber.
- 3) Glue together the 5mm round LED and the Crystal.
- 4) Insert the LED + Crystal in the LED Holder and glue.
Passing the wires (2 X Speaker + 3 X Recharge Port) through the Crystal Chamber:
Nano Biscotte V4.0 Sound Board 3D model by Plecter Labs.
Real pictures of a fully installed chassis in images #11-14, courtesy of Kiefer Jenkins.