Blackographic Proto Bobe Fet Kit
Product Description
Comes with: Helmet, Torso, Arms, backpack, legs. Pistol
Not included: Head, Arms, Hands
Scale: Sized for Minifigures
A bounty hunter based on the original concept art by RMQ. With removeable backpack!
Highly detailed custom parts, see all pictures. Kit comes on a sprue, the sprue is very thin for easier cleanup so it might come off the sprue from shapeways!
NOTES: The frosted extreme detail material is fragile! It is more fragile than injection molded plastic or casting resin so be very careful, these are prototype parts meant for us only but we wanted to share them.
When you get the parts: remove them from sprue, do extra sanding or cutting so the fit is good, paint them if you want, and then put it together, do not do any test fits or the parts might break when you disassemble them! Not meant for pulling on and off continuously!
We do a warm soap bath and scrub with a toothbrush, if the parts feel oily definitely do this. We also put them in the sun or UV light for an hour to make sure they parts are fully cured. Parts pictured are finished using 0000 Super Fine Steel Wool and wetsanding with 600 grit sandpaper.
Body: Head peg sanded for better fit of stock head. Helmet: Clean out any wax if its in the female slot for the head peg, it will be a white substance, we used a toothpick and exacto to get it all out. No other mods needed.
Arms: The most fragile part is the part that pushes into the torso, we sanded the male tip until it pushed into the torso easily. Do not use an exacto, material is fragile! Do not try adding and removing arms to torso repeatedly, the peg will snap off. Stock Hands will go in with no mods.
Helmet: No mods done. Clean out any wax if its in the cavities, it will be a white substance, we used a toothpick and exacto to get it all out.
Legs: No mods done
Not included: Head, Arms, Hands
Scale: Sized for Minifigures
A bounty hunter based on the original concept art by RMQ. With removeable backpack!
Highly detailed custom parts, see all pictures. Kit comes on a sprue, the sprue is very thin for easier cleanup so it might come off the sprue from shapeways!
NOTES: The frosted extreme detail material is fragile! It is more fragile than injection molded plastic or casting resin so be very careful, these are prototype parts meant for us only but we wanted to share them.
When you get the parts: remove them from sprue, do extra sanding or cutting so the fit is good, paint them if you want, and then put it together, do not do any test fits or the parts might break when you disassemble them! Not meant for pulling on and off continuously!
We do a warm soap bath and scrub with a toothbrush, if the parts feel oily definitely do this. We also put them in the sun or UV light for an hour to make sure they parts are fully cured. Parts pictured are finished using 0000 Super Fine Steel Wool and wetsanding with 600 grit sandpaper.
Body: Head peg sanded for better fit of stock head. Helmet: Clean out any wax if its in the female slot for the head peg, it will be a white substance, we used a toothpick and exacto to get it all out. No other mods needed.
Arms: The most fragile part is the part that pushes into the torso, we sanded the male tip until it pushed into the torso easily. Do not use an exacto, material is fragile! Do not try adding and removing arms to torso repeatedly, the peg will snap off. Stock Hands will go in with no mods.
Helmet: No mods done. Clean out any wax if its in the cavities, it will be a white substance, we used a toothpick and exacto to get it all out.
Legs: No mods done
