Shroomie BJD Micro doll

DIY! this is the super tiny Ball jointed doll called shroomie. IOnspired by mushroom caps this tiny doll is a gerat pet or addition to your tiny crew. ASsembly and other tools required.

You will need to cut the parts off the sprue. be careful not to cut the rods in the arms and leg holes to tie cord around.. Grab some .7mm clear beading cord or super thin elastic cord and take a bit of cord and string thorugh one arm and take BOTH ends through the body or shoulder holes and around the other arm hole and tie securly. thae a second piece of cord loop around leg hole and take ONE END though the hip holes thorugh the other leg. Then take the ends from either side back though hip holes and up through torso into neck and then the head. Tie the cords tightly onto a jump ring inside the head.For the jump ring you want a 4mm or maybe a 6mm wide jump ring, nice and thin if possible.The top of the head/mushroom cap should plug onto the bottom of the head. if too tight take a craft blad and thin the inner walls of the lower head to accomadate. The sae for the holes if too small. if printing poweder is stuck inside parts or holes, use a toothpick to clean out.  Paint or blush for all the fun!

check me out and other works on instagram, facebook, youtube, and get stuff like this guy by supporting me on patreon as well as my shop here.

https://www.patreon.com/silverbeam
https://www.instagram.com/silverbeam_dolls/
https://www.youtube.com/user/Ladysilverbeam
https://www.facebook.com/silverbeamdolls/