Click and drag to rotate
Rescue Bots Faceplate Four Pack #1 3d printed

DIGITAL PREVIEW
Not a Photo

Rescue Bots Faceplate Four Pack #1 3d printed
Rescue Bots Faceplate Four Pack #1 3d printed

DIGITAL PREVIEW
Not a Photo

Rescue Bots Faceplate Four Pack #1 3d printed
Rescue Bots Faceplate Four Pack #1 3d printed

DIGITAL PREVIEW
Not a Photo

Rescue Bots Faceplate Four Pack #1 3d printed Hand painted frosted ultra detail prints of Chase and Boulder
Rescue Bots Faceplate Four Pack #1 3d printed Hand painted frosted ultra detail prints of Chase and Boulder

DIGITAL PREVIEW
Not a Photo

Rescue Bots Faceplate Four Pack #1 3d printed Faceplates attached to Titan Masters to demonstrate functionality (Chase and Boulder shown with other prints)
Rescue Bots Faceplate Four Pack #1 3d printed Faceplates attached to Titan Masters to demonstrate functionality (Chase and Boulder shown with other prints)

DIGITAL PREVIEW
Not a Photo

Rescue Bots Faceplate Four Pack #1 3d printed Chase and Boulder shown with other Frosted Ultra Detail prints
Rescue Bots Faceplate Four Pack #1 3d printed Chase and Boulder shown with other Frosted Ultra Detail prints

DIGITAL PREVIEW
Not a Photo

Rescue Bots Faceplate Four Pack #1 3d printed
Rescue Bots Faceplate Four Pack #1 3d printed

DIGITAL PREVIEW
Not a Photo

Rescue Bots Faceplate Four Pack #1

Print With Shapeways
Choose Your Material
$14.75
Choose your color and finish
QTY

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description

A replacement face-kit for Transformers: Titans Return Titan Master figures. This kit combines the Graduate Heatwave, Blades, Chase and Boulder kits into a single sprued kit. 

 

These kits allow for customization of the face while keeping the moving parts and head/body connection from the mass-produced figure for the best fit between head and body.
-
This replacement faceplate connector has been tested using Titan Wars Skullsmasher and Blurr, and should be compatible with most Titan Master mini-figures. As prints vary, some sanding/trimming may be required, and some Titan Masters (like Blurr) lack the rectangular connection peg and gluing may be required to fully secure the face. 
-
Some fine details may not show up clearly on prints in strong & flexible plastic.
-
Instructions: 
Use a toothpick or pin to remove any support material inside the connector ports on the back of the face. 

Paint and seal as desired. Detail plastic prints will need a light washing with soap and water prior to painting to remove support material residue. 

Unscrew the screw in the Titan Master's chest. Remove the original face-plate. Place the new face plate on the figure, replace the screw. 

The port does not come pre-threaded, so the initial installation will be tight. If the screw connection is too loose you can secure it with a drop of superglue inside the port prior to reinstalling the screw.

Details
What's in the box:
Graduate Faceplate Four Pack #1
Dimensions:
2.92 x 0.68 x 3.52 cm
Switch to inches
1.15 x 0.27 x 1.39 inches
Switch to cm
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.