Ok finally got an ABS version of this to bring the price down for everyone. Had to slightly modify the original in FXD/FUD a bit to compensate. The full HD version can be found here:
Turret Tube Hall Replacement HD for DeAgo Falcon
The biggest change was I had to cut holes in the back of the walls so that light could get thru. You should fill this in with either a hazed clear plastic or hot glue to get the right light dispersal. Second I had to move the ladder attachments to the middle of the cushions. With the holes in the walls, it would be impossible to attach them there anymore. But I don't think it will be very noticeable once installed. The only part that needs printing in FXD/FUD is the ladder. The rungs are too thin and look way to thick in ABS. You can get that part here:
ABS Turret Tube Ladder for DeAgo Falcon
This kit contains 5 parts:
1 - Top Section (printing is always facing up)
1 - Bottom Section (printing facing down)
1 - Rear Hall Section (tabs only fit one way)
1 - Right Front Wall Panel
1 - Left Front Wall Panel
Should be pretty self explanatory to put together. Hope you all enjoy this! Please let me know!