A roll cage for the typical 1/10 3door Jeep Wrangler RC body.
You will need some 2,5 and 3mm bolts:
- The cage is joint by six 2,5mm bolts.
- To attach the roll cage to body it uses 6 existing holes of the body (4 in the back and 2 in the windshield, all of them with 3mm bolts) and you need to make 2 new holes in the front (which already exist under the hood, you only need to screw longer 2,5mm bolts and get it out of the hood to screw the cage).
This version has a rear reinforcement bar (which is only shown in some photos) but no light bar included.