Pioneer '68 Mustang & Camaro Chassis for Slot.it

Always check out our main page for the latest updates in the store : Click Here 


UPDATE 3/9/17 ~ Screw hole sizes have been updated.

1/32 Pioneer Mustang & Camaro Slot Car Chassis

• Limited lifetime guarantee - if it breaks, Changing Gearz will replace it!!!
• Light weight and strong
• Lower Center of Gravity than Stock Chassis
• Accepts Slot.it Sidewinder or Inline motor pod 
• Accepts 2mm axle height adjusters on front axle (SCC rounded 2mm or slot.it 2mm)
• Accepts Slot.it axle bushings (CH56) for front axle (optional)
• ribbing to control chassis flex
• Strengthened body mount pads
• Motor wire stays molded in
• Fits all Pioneer 1968 Camaro and Mustang models
• Minor cockpit trimming required for proper fit * New low profile cockpit coming soon. No trimming!

changing.gearz@gmail.com


Compatible Cars (not all models shown - there are many!)


Steps for interior:

**Consider a "photo cockpit" before trimming interior - pop/pry interior out of car, take a photo of interior from above and print out on photo paper. Remove driver helmet from stock interior poke a hole in helmet location and glue in place on paper. Tape paper to interior of car

**Lighteweight interior option will be available soon from us using existing mounts and helmet.

To trim stock Cockpit:
Install CGin3D chassis on to body without motor pod (so you can clearly see interior)

With a marker - draw a line in the region where pod would interfere  ~ from the motor pod mounting hole toward the rear.

Cut away material

Install