This is the twenty sided die (D20) from my 'Floral 2' collcection.
It measures about 28 mm (1.1 inch) from side to side, and 32 mm (1.3 inch) from point to point. This design is hollow and was optimised for printing in steel or any of the other metals. In steel this die weighs about 33 grams. The die is well balanced and gives a fair roll.
This 20 sided die follows the
regular numbering as seen on most gaming dice, in which the numbers on opposing sides always sum to 21. This same design is also available with 'spindown' numbering, to be used as a life counter in games such as Magic: the Gathering
here. A larger version of this die, which is better suited for printing in plastic, is available
here.
For all the other dice in this set, please have a look at the
'Floral' category in my shop.
Please be advised that, due to the level of detail of this design, when printed in unfinished stainless steel, there will likely be some residual bits of polishing medium stuck to your print. You can easily remove these bits of polishing medium with the help of a pin or wire brush. (This is what these bits look like.) This happens only with the base stainless steel material, not with any of the other finishes.