You must be logged in and verified to contact the designer.
Product Description
Custom designed shell for TurboED PCB V2.2 & V2.4
Redesigned from scratch with a little hint of PC-Engine DUO styling to accommodate the new board layout.
To install, simply apply a very small amount of latex caulk or any non-permanent adhesive at the base of the four pegs. Attach the shell on to the PCB, wrap few rubber bands around the assembly and allow ample time for drying.
NOTE:
This shell is designed strictly to work with PCB version 2.2 and 2.4 only and will not fit 2.1, 2.3 nor the older 1.1 or 1.2 boards. Fitment on future PCB revisions is not certain due to potential different placement of components. BuffaloWing has no control of future changes in PCB designs nor has input on the design of the PCB layout.
Depending on how Shapeways prepare your order, this part may exhibit more "stepping" texture on the curved surface on some occassions. BuffaloWing has no control over this. If this is unacceptable to you, conisder the V2 Low Profile version of the shell instead.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: